How to Use a Brick Making Machine: Step-by-Step Guide
Preparation Prior to Operation
Location & Power Check
(1) For fixed models: Check the factory floor leveling and load (≥ 2 ton/m²) .
(2) For mobile models: On flat land and close to the construction site for use (especially for the one used by Li Hongmei).
(3) Three phase power (380V) connection and check for leaks in circuit.
Raw Material Preparation
(1) Gather the essential materials (cement, sand, aggregates) and optional recycled materials (maximum 30% recycled materials such as construction waste, tailings, or gangue, that is the setup of Zhang Jianguo and Chen Liwei).
(2) Sift the raw materials to remove any particles larger than 5mm to prevent the particles from getting stuck in the feeding system. Equipment Check
(1) Inspect the hydraulic system for proper oil levels, check that the pressing mold is tight, and check the conveyor belt for cleanliness.
(2) Check that the touch screen (for intelligent models) or the servo motor control system (for precision models) is powered on properly. 2. Mixing and Blending of Raw Materials
Set the Ratio
Use a touch screen to input the desired ratio for the materials (e.g., cement:sand:aggregate - 1:3:5). For recycled materials, follow the machine's recommendations for maximum percentage (typically a maximum of 30% recycled material is acceptable in most machines).
Stir the materials until uniform
Pour the raw materials in the mixer, add water (and water-cement ratio, 0.35-0.4) and stir for approximately 3-5 minutes until the mixture is uniform and will not drip—this is important for the strength of the bricks (this is important for Li Hongmei's needs in the construction site).
Debugging of the Equipments
Set the parameters
The parameters can be set through the touch screen based on input from the operator: brick type (FW:Standard brick,582: Dutch brick,537: permeable brick, size (240×115×53 mm), pressing pressure (15-20MPa), output speed (produced based maximum output for the machine and appropriate output speed to day - maximum contracted output is 8000 pcs. Because we are a reputable and established company with extensive experience and can provide manuals and specifications with all blender machines.
05
Aug
05
Aug
05
Aug
05
Aug
"In the past, our an old machine could produce 3000 standard bricks per day, and workers' complaints were rampant with exhaustion and the electric bill being flat out ridiculous. Now that we've changed to this brick making machine, we are producing raised to 8000, and both the fabric and pressing process is fully automated so it only takes two worker to monitor it. The best part is it can mix 30% of building demolition debris. This is both a cost saving measure for our raw material and meets the environmental protection we discuss so often. Over the last six months, net profit has increased 40%. "
"When I began my journey as an entrepreneur, I focused on the environmentally friendly building materials field, and we analyzed over ten companies regarding equipment selection. This brick machine can use local tailings and coal gangue, and these permeable bricks not only meet the sponge city standards but also receive local environmental subsidies. The intelligent touch screen operation is relatively easy, and my cousin, who just graduated, learned it in half a day. Today, we are selling over 100,000 bricks monthly."
Linyi Fuda Machinery manufactures high-quality concrete and clay block machines for global construction needs. With over 20 years of experience, we export to 60+ countries, offering full production lines, ODM services, and overseas support. Get a reliable brick machine solution today.
Zhuanbu District, Yinan County, Linyi City, Shandong Province, China.
Copyright © Linyi Yingcheng International Trade Co., Ltd. | Privacy policy
EN
